Greasing The Gas Tap - Angelo Po 291FAGF Manual De Uso E Instalación

3 - Remove the rack (C).
4 - Undo the screws and remove the guard (D).
5 - Undo the locking screw (E).
6 - Set the bush (F) in contact at the distance
shown in the figure.
7 - Tighten the screw (E).
8 - Replace the panel (D) and the rack (C) on
completion of the operation.
IT
GB

GREASING THE GAS TAP

DE
To carry out this operation, proceed as follows.
1 - Turn off the gas supply tap.
FR
2 - Pull off the knob (A).
3 - Undo the screws (C) and remove the control
panel (B).
ES
4 - Undo the screws (D) and extract the cap (E).
5 - Pull off the cone (F).
6 - Clean the cone (F) and its seat.
7 - Coat the cone with grease (F), fit it in its seat
and turn it a few times.
8 - Pull off the cone (F) to remove the excess
grease.
9 - Replace the cone (F) and the cap (E).
10 - Replace the control panel (B) and the knobs (A)
on completion of the operation.
English
C
D
F
C
A C B
- 26 -
IDM-39617002700.tif
E
IDM-39617001700.tif
E F
D
IDM-39614602300.tif