Selecting The Automatic Switch-Off Time; Anti-Allergy Temperature Setting - Beurer UB 90 Instrucciones Para El Uso

Level 0: off
Level 1: minimum heat
Level 2 – 8: individual heat
Level 9: minimum heat
Note: Switching sequence of the temperature settings: 0 – 9 – 8 – 7 – 6 – 5 – 4 – 3 – 2 – 1 – 0 – 9 ...
Note: This electric underblanket has a rapid heating function, allowing for faster
warming in the fi rst 15 minutes. During this time, "Turbo" fl ashes on the display.
If using the blanket for several hours, set the lowest temperature setting (level 1) for
the body area and foot area.
Note: This electric underblanket features an automatic switch-back for safety purposes. Tem-
perature settings 9, 8 and 7 are automatically switched to temperature setting 6 after 3 hours.

3.6 Selecting the automatic switch-off time

Press the button to set the automatic switch-off time [4]. You can set the automatic
switch-off time as 1, 2, 3, 4, etc. or 12 hours.
Note: Switching sequence of the automatic switch-off time:
1 h – 12 h – 11 h – 10 h – 9 h etc. 1 h – 12 h – 11 h etc. (time in hours).
If the time remaining is under an hour it is shown in minutes (e.g. 59 min.)
The electric underblanket is automatically switched off once the set switch-off time has elapsed.
The following is then shown in the display:
Temperature setting for body area: 0
Temperature setting for foot area: 0
Automatic switch-off time: "0 min" fl ashes
To switch on the electric underblanket again, press either the button to set the temperature
setting of the body area or of the foot area.
If you do not want to use the electric underblanket beyond the selected switch-off time, slide
the ON/OFF switch to the OFF ( 0 ) position to switch off the electric underblanket.
3.7 ECO control
Temperature settings 1, 2 and 3 are particularly energy-effi cient. If these temperature
settings have been selected, the "ECO" symbol is shown in the display.
3.8 kWh display
Press the "kWh" [7] button to display the current power consumption in kWh. The power con-
sumed since the last switch-on is displayed.
Due to the low power consumption in the "ECO" temperature settings, the displayed value
(power consumption in kWh) takes a while to change. If both zones are set to temperature set-
ting '9', it will take approx. 8 minutes for the display to change from 0.00 kWh to 0.01 kWh.
Note: A healthy sleeping environment can be achieved by keeping the bedroom cool and pre-
heating your bed shortly before going to bed. Lower heating costs for the bedroom also create
further cost savings.

3.9 Anti-allergy temperature setting

Useful information
In recent years, the number of people allergic to domestic dust has risen sharply. Typical
symptoms of this allergy are irritated eyes, sneezing fi ts, coughing fi ts and shortness of breath
in the early morning. These reactions are triggered by proteins in the excrement of the house
dust mite. Mites are almost always present in warm and humid microclimates, as are often
found in beds. They feed mainly on human skin scales and mildew and can be found in every
house. Even with regular and thorough cleaning, dust and skin cells continuously build up.
13
Individual
CONTROL