Additional Control Input/Output Wiring - Franklin Electric SubDrive Connect Serie Manual De Usuario/Instalador

Additional Control Input/Output Wiring

1. Built-In Duplex Alternator – Use the ALTERNATOR terminals to connect two drives in a lead/
lag configuration. Refer to
Alternator communication cable should for this connection. Refer to
• Connect the black cable lead to the A terminal on both drives.
• Connect the red cable lead to the B terminal on both drives.
• Connect the green cable lead to the
IMPORTANT: Both drives should be wired from the same panel to ensure proper communica-
tion and operation.
2. Moisture Sensor – The WET SENSOR terminal supports the Franklin Electric Moisture Sensor.
• Connect the red cable lead to the +24 terminal.
• Connect the black cable lead to the
• Connect the white cable lead to the I+ terminal.
• Connect the green cable lead to the I– terminal.
Refer to "Moisture Sensor" on page 32
"Duplex Alternator Feature" on page
terminal when applicable.
terminal.
for more information about configuring this input.
INSTALLATION AND SETUP
42. An appropriate Duplex
"Accessories" on page
Electrical Installation
54.
25