Baby auto G-CAT 123 Manual De Uso página 29

3. Place your child sit down in the child seat.
4. Make sure that your child's back lies flat against the backrest of the
child seat.
5. Guide the two buckle latches together and engage them before
putting them into the harness buckle
noise (fig.15,16,17).
6. Pull on the adjuster strap
against your child's body.
For the safety of your child, before every journey in the car check that...
• the child safety seat is engaged on both sides with the ISOFIT locking arms
(M) in theISOFIX attachment points and that both green safety buttons
completely green.
• the child seat is firmly installed in the vehicle.
• the Top Tether is tightly tensioned over the backrest of the car seat and the
tension indicator is green.
• the straps of the child safety seat are close to the body without constricting the
child.
• the shoulder belts
• the shoulder pads
• the buckle latches are engaged in the harness buckle (E).
4.2 GROUP 1 (9-18 kg). Vehicle belt
1. Make sure that the child seat's 5-point harness is installed correctly
(see section 7).
2. Follow the steps in section 3.2 ( to adjust headrest).
3. Place the child seat facing in the direction of travel on the vehicle
seat.
4. Pull the vehicle belt out and guide it through the belt guides of the
child seat. Make sure that the belt is not twisted (fig.20).
5. Engage the buckle tongue in the vehicle seat buckle this should make
a click noise (fig.21).
6. On the side opposite the car seat belt buckle, press lever
down and insert diagonal belt in belt lock-off (fig.22).
7. Apply your body weight to the child seat (kneel into the seat). At the
same time pull the diagonal belt strongly to tighten .
8. Follow the steps in section securing your child with 5-point harness.
(G)
(D) are correctly adjusted and the straps are not twisted.
(C) are at the same level as your child's shoulders.
- this should make a click
(E)
until the harness lies flat and is close
(R) are
and hold
(O)
29