Servo Assignment/Receiver Output Sequence; Template:4Flaps; Transmitter Controls / Switches - Multiplex ROYALevo 7 Manual De Instrucciones

ROYAL evo 7

20.6. Template:4FLAPS

Suitable for gliders with four-flap wings, especially F3B
and F3J types, with normal tail (cruciform or T-tail) or V-
tail, and options including aero-tow release or motor.
The model type includes flight phase switching.
Typical models: Milan, Euro/Elektro-Master, ALPINA,
ASW27B, DG600evo
AILERON+
FLAP+
Rudder
ELEVATR+
AILERON+
FLAP+
V-TAIL+
V-TAIL+
fixed
assignment
20.6.1.

Transmitter controls / switches

Name of assignment:
Physical
Control Note
control
Idle position = back
Throttle E
Can be altered (
Spoiler retracted = forward
‡
Spoiler
Can be altered (
Stick
Flap F Control for camber-changing flaps
L-Gear O Retract
Aero-tow G Aero-tow release
Brake G
Gyro E
Mixture F
AUX1 L Auxiliary channel 1 (e.g. variometer)
AUX2 G Auxiliary channel 2
p.ex.:
tow release,
spoiler,
retract
FLAP+
AILERON+
e.g.:
tow release,
spoiler,
retract
FLAP+
AILERON+
assigned but
vacant
alterable
GLIDER
13.3.3.)
13.3.4.)
Physical
Switch
control
D-R L
N
CS
THR-CUT H
Timer E
SNAP/FLAP
I
Mix-1
Mix-2 G
Mix-3 L
Teacher M
F-PH 1-3 J
20.6.2. Servo assignment /
receiver output sequence
MPX
1 AILER.+ (L)
2 ELEVATR+* ELEVATR+* ELEVATR+*
3 Rudder*
4 -----
5 AILER.+ (R)
6 FLAP+ (L)
7 FLAP+ (R)
Channels with a grey background cannot be changed!
Channels marked "-----" can be assigned freely (
* automatically changes to V-TAIL+ if the V-Tail
mixer is activated (= ON )
( 15.1.).
Important: receiver socket sequence of wing servos
It is important to observe the stated connection se-
quence of the aileron servos, and the servos with an ai-
leron input (AILERON+, FLAP+), at the receiver. The ser-
vos must always be connected alternately left (L) and
right (R) with rising channel numbers (1, 2, 3, ...7), or in
the reverse order right (R) and left (L). If you neglect to
do this, the correct operation of aileron differential can-
not be guaranteed.
Page 66
Dual-Rate switch for
aileron, elevator and rudder
Combi-Switch
EMERGENCY throttle CUT
Runs when slider E (THROTTLE) =
forward
Can be altered ( 17.)
Switch for SNAP-FLAP
Switch for A/B mixer (
Switch for A/B mixer (
Switch for A/B mixer (
Trainer switch
Flight phase switch
Hitec Futaba
AILER.+ (L) AILER.+ (L)
----- -----
Rudder* Rudder*
AILER.+ (R) AILER.+ (R)
FLAP+ (L) FLAP+ (L)
FLAP+ (R) AILER.+ (R)
9.2.)
9.2.)
9.2.)
JR
-----
AILER.+ (L)
ELEVATR+*
Rudder*
AILER.+ (R)
FLAP+ (L)
FLAP+ (R)
16.2.).