Template: Helimech; Transmitter Controls And Switches - Multiplex ROYALevo 7 Manual De Instrucciones

You can minimise these problems as follows:
1. Fit the servo output arm on the flap and aileron
servos at right-angles to the pushrods.
2. Determine the centre of the working range of the
control surface:
Example: the working range of the control surface
(e.g. flap) is +20° ... -60°, starting from the neutral
position (control surface in line with airfoil)
the centre of the working range of the control
surface is therefore at -10°.
Adjust the control surface pushrod so that the con-
trol surface is at -10° when the servo is at centre.
TIP:
When you select the servo in the Servo / Cali-
brate menu, select the percentage value for point
P3 and then press the digi-adjustor assign button
< F >: the servo will then run to its exact neutral
point ( 16.1.).
Both FLAP+ and AILERON+ servos should now be
3.
calibrated at points P1 , P3 , and P5 (also points P2
and P4 if used) so that both control surfaces on
each side line up exactly at all points (in our exam-
ple at +20° / -10° / -60°).
Now adjust the Off (offset) parameter of the
4.
Spoiler input in the FLAP+ and AILERON+ mix-
ers so that the control surfaces follow the wing air-
foil exactly.
The diagram below shows how this system works in
comprehensible graphic form:
Flap at neutral position,
servo offset by"Offset"
Off
(Offset)
servo centre
new servo neutral position
Flap up-deflection,
e.g. for AILERON function
Flap deflection increased by "Offset",
for Butterfly / Crow
Offset + travel
Trvl
ROYAL evo 7 - Instructions

20.7. Template: HELImech

Suitable for model helicopters with mechanical rotor
head mixing.
Collect.
e.g.:
speed controller
Gyro
TAIL
fixed
assignment
20.7.1.

Transmitter controls and switches

Name of assignment:
Physical
Control
control
‡
Coll. pitch
Stick
Throttle
F
limit
Spoiler O
RPM G
L-Gear O
Aero-tow G
Brake G
Gyro E
Mixture E
AUX1 L
AUX2 G
Physical
Switch
control
L
D-R
DTC N
THR-CUT H
Timer F
Mix-1 I
Mix-2 G
Mix-3 L
Teacher M
A-ROT I
F-PH 1-3 J
Page 69
Elevator
(pitch-axis)
Aileron
(roll)
Throttle
assigned but
vacant
alterable
HELI
Note
Coll. minimum (descent) = back
Can be altered ( 13.3.3.)
Thr. minimum (idle) = back
Can be altered ( 13.3.4.)
Speed governor switch (
Retracts
Gyro gain adjustment
Auxiliary channel 1
Auxiliary channel 2
Dual-Rate switch for
roll, pitch-axis, yaw (tail rotor)
Direct Throttle Control
EMERGENCY throttle CUT
Runs when slider F (throttle limiter)
= forward
Can be altered ( 17.)
Switch for A/B mixer ( 9.2.)
Switch for A/B mixer ( 9.2.)
Switch for A/B mixer ( 9.2.)
Trainer switch
Auto-rotation switch (activates
flight phase 4: AUTOROT )
Flight phase switch
9.2.)