Mounting The Bike Handle - Stihl FS 565 Manual De Instrucciones

Mounting the Bike Handle

Mounting the Handlebar
Mount the handlebar on the drive tube
about 4 in (10 cm) forward of the engine
housing.
3
5
4
1
6
N Place the handle support (1) on the
drive tube (2).
N Place the handlebar (3) in the
handle support.
N Fit the clamp (4) on the handle
support. Insert the screws (5)
through the holes in the parts and
screw them into clamp (6) as far as
stop – tighten them only moderately
at this stage.
FS 56, FS 56 R, FS 56 C, FS 56 RC
Mounting the control handle
3
2
N Take out the screw (1) – the nut (2)
remains in the control handle (3).
N Push the control handle onto the
2
end of the handlebar (5) until the
holes (6) line up – the throttle
trigger (4) must point towards the
gearbox.
N
Insert the screw (1) and tighten it
down firmly.
4
6
1
5
6
Adjusting and Securing the
Handlebar
A
1
B
N
Align the handlebar so that
distance (A) is about 8 in (20 cm)
and distance (B) about 6 in
(15 cm).
N Tighten down the screws (1) firmly
in a crosswise pattern.
Fitting the Throttle Cable
Do not kink the throttle cable or
lay it in tight radii – make sure the
throttle trigger moves freely.
English
17