Setting The Pin Code; Pairing Bluetooth® Adapter And Bluetooth Wireless Technology Device - Pioneer X-SMC1-K Manual De Instrucciones

®
Bluetooth
Audio playback (optional)
2 Press STANDBY/ON to turn the power on.
Press FUNCTION / or BT AUDIO on the
3
front panel of the unit to select BT AUDIO as the
1
input source.
The BT AUDIO indicator lights and
front panel display.

Setting the PIN code

Set this unit's PIN code to the same setting as that for the
Bluetooth wireless technology device used. Supported PIN
code setting values include 0000, 1234 or 8888.
• Default setting: 0000
1 Press SET UP continuously to select
.
• Each time SET UP is pressed the item on the front panel
display changes accordingly.
2 Press ENTER continuously to select the PIN
code .
/
• Each time is pressed the item on the front panel
display changes accordingly.
• You can select the PIN number from 0000/1234/8888.
3 Press ENTER.
The PIN code is stored.
4 Press SET UP.
The setting is completed.
Note
®
1 When the Bluetooth adapter is not connected and BT AUDIO is selected as the input source, the error message noAdP. will be shown
on the front panel display.
2 • Pairing is required when you first use Bluetooth wireless technology device and Bluetooth
• To enable Bluetooth communication, pairing should be done with both of your system and Bluetooth wireless technology device.
Pairing Bluetooth
Bluetooth wireless technology device
"Pairing" must be done before you start playback of Bluetooth
wireless technology content using Bluetooth
is shown on the
sure to pair devices the first time you operate the system or
any time pairing data is cleared. "Pairing" is the step
necessary to register Bluetooth wireless technology device to
enable Bluetooth communications.
also the operating instructions of your Bluetooth wireless
technology device.
Press FUNCTION / or BT AUDIO on the
1
front panel of the unit to select BT AUDIO as the
input source.
The BT AUDIO indicator lights .
• When Bluetooth
seconds, then
• When no Bluetooth
shown on the front panel display for 2 seconds, then
2 Turn on the
device that you want to pair, place it near the
system and set it into pairing mode.
Pairing starts.
3 Check to see that the
detected by the
device.
• If the Bluetooth wireless technology device cannot be
connected to the unit, perform the connection operation
from the Bluetooth wireless technology device.
®
adapter and
2
For more details, see
®
adapter AS-BT200 is connected,
is shown on the front panel display for 2
is shown.
®
adapter is connected,
is shown.
Bluetooth
wireless technology
Bluetooth
Bluetooth wireless technology
®
adapter.
06
®
adapter. Make
is
®
adapter is
19
En