Setting The Clock (Remote Control Only); Input Button - Pioneer X-HM30V-S Manual De Instrucciones

General control (continued)
n Auto power off function
The main unit will enter the stand-by mode (when iPod or
iPhone is not docked) after 15 minutes of inactivity during:
iPod or iPhone: No connection.
Line In: No detection of input signal or very low sound
audibility.
DISC/USB Audio/USB Video: In the stop mode.
Note:
However, if iPod or iPhone is docked, the unit will begin
charging.
"Charge Mode" will be displayed.
n Muting
The volume is muted temporarily when pressing the
MUTE button on the remote control. Press again to restore
the volume.
n P.Bass control
When the power is first turned on, the unit will enter P.Bass
mode which emphasises the bass frequencies.
To cancel the P.Bass mode, press the P.BASS button on
the remote control.
n Bass control
1 Press the BASS/TREBLE button to select "BASS".
2 Within 5 seconds, press the VOL (+ or –) button to
adjust the bass.
n Treble control
1 Press the BASS/TREBLE button to select "TREBLE".
2 Within 5 seconds, press the VOL (+ or –) button to
adjust the treble.
n Function
When the INPUT button on main unit is pressed, the
current function will change to different mode. Press the
INPUT button repeatedly to select desired function.
DISC FM
(DVD/CD) STEREO
Line In iPod
Note:
The backup function will protect the memorised function
mode for a few hours should there be a power failure or the
AC power lead becomes disconnected.
All manuals and user guides at all-guides.com
........
-5 -4 +4 +5
........
-5 -4 +4 +5
FM MONO AM
USB Video USB Audio

Setting the clock (Remote control only)

STANDBY/ON
PRESET
In this example, the clock is set for the 24-hour (00:00)
display.
1 Press the STANDBY/ON button to turn the power on.
2 Press the CLOCK/TIMER button.
3 Within 10 seconds, press the ENTER button. To adjust
the day, press the
ENTER button.
4 Press the or
hour display and then press the ENTER button.
The 24-hour display will appear.
(00:00 - 23:59)
The 12-hour display will appear.
(AM 12:00 - PM 11:59)
5 To adjust the hour, press the
press the ENTER button. Press the
once to advance the time by 1 hour. Hold it down to
advance continuously.
6 To adjust the minutes, press the
then press the ENTER button. Press the
button once to advance the time by 1 minute.
To confirm the time display:
Press the CLOCK/TIMER button. The time display will
appear for about 5 seconds.
Note:
When power supply is restored after unit is plugged in
again or after a power failure, reset the clock (page 42).
To readjust the clock:
Perform "Setting the clock" from step 1. If the "Clock" does
not appear in step 2, step 4 (for selecting the 24-hour or
12-hour display) will be skipped.
To change the 24-hour or 12-hour display:
1 Clear all the programmed contents. [Refer to "Factory
reset, clearing all memory" on page 43 for details.]
2 Perform "Setting the clock" from step 1 onwards.
En-18
CLOCK/TIMER
MEMORY/FOLDER
+
PRESET
DVD/CD
ENTER
or button and then press the
button to select 24-hour or 12-
or button and then
or button
or button and
or