Setting Date And Time - smartheart 01-509 Manual De Instrucciones

SETTING DATE/TIME
IT IS NECESSARY TO SET THE DATE AND TIME FOR THE UNIT
EVERY TIME BATTERIES ARE INITIALLY INSTALLED OR REPLACED.
The date/time feature is on the bottom right
of the display screen. This unit stores the
date, time and year allowing for a date/
time stamp on all readings in the memory
recall function. The date/time alternate view
while in use.
The MEMORY RECALL and U1 buttons are
located on the bottom center of the monitor
and are necessary for setting the date/time
of this device.
HOW TO SET DATE AND TIME
1. When the unit is off (a blank display screen), press and hold the U1/SET
button for 3-5 seconds to enter clock setting mode.
2. HOURS/MINUTES—first the hour will flash on the display. Press the
MEMORY button to advance the display to the desired hour, press the U1/
SET button to confirm your selection and advance to the minute setting. Press
the MEMORY button to advance to the correct minute, press U1/SET to
confirm.
3. MONTH—next the Month will flash on the display. Press the MEMORY
button to advance the display to the desired month, press the U1/SET button
to confirm your selection and advance to the date settings.
10 • ENGLISH
MEMORY U1/SET
Recall Button
1 2
U2
Button Button