Setting Date/Time - smartheart 01-540 Manual De Instrucciones

SETTING DATE/TIME

IT IS NECESSARY TO SET THE DATE AND TIME FOR THE
UNIT EVERY TIME BATTERIES ARE INITIALLY INSTALLED OR
REPLACED.
DATE AND TIME WILL DEFAULT TO FACTORY SETTINGS,
12:00/1(M)-1(D), IF YOU DO NOT CHOOSE TO SET THE
CORRECT DATA.
The date/time feature is on the bottom left of
the display screen, Fig 1. The date and time will
alternate every four seconds regardless of the
operating mode.
1. When the unit is off, press and hold the START
and MEM button at the same time. The unit will
beep once and the month will begin to flash,
Fig. 2.
2. Press the MEM button to change until the
desired number appears. To scroll through the
numbers quicker, hold down the MEM button
as the numbers advance.
12 • ENGLISH
MEM and START/
The
POWER
buttons are located
on the right side of the
monitor.
Fig. 1
1 2
Fig. 2