Installing Framing For Hood Support; Mounting The Hood - arietta Dekor Glass 30 Guía De Instalación, Uso Y Mantenimiento

Install framing for hood support
If drywall is present, mark the screw hole locations. Remove the template.
•
• Cut away enough drywall to expose 2 vertical studs at the holes location indicated by the template.
Install two horizontal supports at least
installation location.
The horizontal support must be flush with the room side of the studs.
•
Use cleats behind both sides of the support to secure to wall studs.
Reinstall drywall and refinish.
•
IMPORTANT- Framing must be capable of supporting 100 lbs.

Mounting the hood

WARNING: 2 people are required to lift and position the hood onto the mounting screws.
Place the template on the wall along the horizontal line, make sure the template is leveled and centered
•
with the centerline.
Mark "upper" screw holes locations in the wall.
•
• IMPORTANT. Check to be sure that hole locations are leveled and correctly centered by the vertical centerline.
Drive "upper" wood screws by hand. Leave ¼ " of distance between the screw head and the wall.
•
Mount the hood onto the "upper" screws.
•
• Mark "lower" wood screw holes locations in the wall using a pencil.
1" X 6" between two wall studs at the bottom mounting holes
6"
18