Mounting The Hood; Electrical Connection - arietta ALS436SS Guía De Instrucciones Para Instalación

Mounting the hood

1.
Install transition on top of hood (if removed for shipping) with
2 - 3.5 x 9.5 mm sheet metal screws.
A. Vent transition
B. 3.5 x 9.5 mm screw
WARNING
2 people are required to lift and position the hood
onto the mounting screws.
■ Place the template on the wall along the horizontal line, make sure
the template is leveled and centered with the centerline.
■ Mark "upper" screw holes locations in the wall
IMPORTANT: Check to be sure that hole locations are leveled and
correctly centered bye the vertical centerline.
■ Drive "upper" wood screws by hand. Leave ¼" of distance between
the screw head and the wall.
¼˝
(6.4mm)
■ Remove the grease filter and mount the hood onto the "upper screws".
B
A
■ Mark "lower" wood screw holes locations in wall using a pencil.
■ Remove the hood.
■ Drive the "lower" wood screws, by hand. Remove screws.
■ Mount the hood onto the "upper" wood screws, by hand.
■ Drive and tighten the "lower" wood screws, by hand.
A
B
A. 5 x 45 mm screw
B. Mounting slots

Electrical Connection

WARNING
Electrical Shock Hazard
Warning: Turn off the power circuit at the service
panel before wiring this unit.
120 VAC, 15 or 20 Amp circuit required.
ELECTRICAL GROUNDING INSTRUCTIONS
THIS APPLIANCE IS FITTED
BOX WITH 3 WIRES, ONE OF WHICH (GREEN/YELLOW) SERVES
TO GROUND THE APPLIANCE. TO PROTECT YOU AGAINST
ELECTRIC SHOCK, THE GREEN AND YELLOW WIRE MUST BE
CONNECTED TO THE GROUNDING WIRE IN YOUR HOME ELEC-
TRICAL SYSTEM, AND IT MUST UNDER NO CIRCUMSTANCES BE
CUT OR REMOVED.
Failure to do so can result in death or electrical shock.
6
A
WITH AN ELECTRICAL JUNCTION