Using External Equipments; Listening To External Equipment; Changing The Equipment's Name - JVC FS-X1 Manual De Instrucciones

Using External Equipments

2
Listening to External
Equipment
You can listen to the external equipment such as MD re-
corder, tape deck or other auxiliary.
❑ First make sure that the external equipment is properly
connected to the System. (See page 8).
1
Set the VOLUME control to the mini-
mum position.
2
Press the LINE button on the Remote
Control.
"LINE" will appear on the display.
• You can also select "LINE" using the Source selector
on the Unit.
3
Start playing the external equipment.
4
Adjust the VOLUME control to the
desired listening level.
5
Apply the following sound effects, if you
wish.
• AHB PRO (See page 11.)
• Tone (BASS/TREBLE) (See page 12.)
To exit the source "LINE", select other source (e.g.
CD).
• For operation of the external equipment, refer to its In-
structions.
SET
3
LINE
Source
selector

Changing the Equipment's Name

You can change the equipment's name according to the
equipment to be used. (At purchase, "LINE" is selected.)
On the Remote Control
1
2
3
4
5
• The selected name will appear on the display when you
Press the LINE button to select the
source "LINE".
Press the LINE button for two seconds
or more.
"NAME CHANGE" blinks on the display.
While "NAME CHANGE" is blinking,
press the SET button.
3 2
Press the or button repeatedly to
select the desired name.
Each time you press the button, the equipment name
changes as follows.
LINE Ô TAPE Ô DBS Ô VCR Ô TVÔ
GAME Ô (back to the beginning)
DBS (Direct Broadcasting Satellite): For CS/BS
Press the SET button
The current name is replaced with new one.
(When TAPE is selected)
select the source "LINE".
20