Connecting The Speakers (Sp-Fsx1/Sp-Fsx3) - JVC FS-X1 Manual De Instrucciones

Getting Started

Connecting the Speakers (SP-FSX1/SP-FSX3)

These speakers are exclusively for this system. Using with other devices will damage the speakers.
Connect the speaker cords between the speaker terminals of the Unit and those of the Speakers.
• When inserting the speaker wire lead, open the speaker terminal.
• Connect the black cord to the ( - ) terminal and the cord without a black line to the (+) terminal.
Right side (rear view)
BLACK
SP-FSX1
SP-FSX3
BLACK
• Since both speakers are the same, you can put either one to the right or left side.
• Do not connect other speakers to the Unit. The difference of the load impedance causes failures.
• Do not use the supplied speakers in parallel with other speakers.
CAUTION:
• A TV may display irregular colors if located near the speakers. If this happens, set the speak-
ers away from the TV.
7
Left side (rear view)
BLACK
BLACK
SPEAKER terminal description
(on the side panel)
BLACK
BLACK BLACK
SPEAKER terminal description
(on the side panel)
BLACK
SP-FSX1
SP-FSX3