Connecting The Am Antenna - JVC FS-X1 Manual De Instrucciones

Connecting the AM Antenna

Rear Panel of the Center Unit (CA-FSX1/CA-FSX3)
AM loop antenna (Supplied)
Attach the AM loop to its base by snapping the tabs on
the loop into the slot in the base.
• If the AM loop antenna wire is covered with vinyl, remove the vinyl by twisting it as shown in the diagram.
• Make sure the antenna conductors do not touch any other terminals, connecting cords and power cord.
This could cause poor reception.
• If reception is poor, connect an outdoor single vinyl-covered wire to the AM EXT terminal. (Keep the AM loop
antenna connected.)
Outdoor single vinyl-covered wire (not supplied)
Turn the loop until you have the best reception.
Getting Started
6