Care And Maintenance; General Notes; Moisture Condensation - JVC FS-X1 Manual De Instrucciones

Care And Maintenance

Handle your CDs carefully, and they will last a long time.
Compact Discs
• Only CDs bearing these marks
can be used with this System.
However, continued use of irregu-
lar shape CDs (heart-shape,
octagonal, etc.) can damage the
System.
• Remove the CD from its case by
holding it at the edges while press-
ing the case's center hole lightly.
• Do not touch the shiny surface of
the CD, or bend the CD.
• Put the CD back in its case after
use to prevent warping.
• Be careful not to scratch the sur-
face of the CD when placing it
back in the case.
• Avoid exposure to direct sunlight,
temperature extremes, and moisture.
• A dirty CD may not play cor-
rectly. If a CD does become dirty,
wipe it with a soft cloth in a
straight line from center to edge.
CAUTION:
• Do not use any solvent (for example, con-
ventional record cleaner, spray thinner,
benzine, etc.) to clean a CD.

General Notes

In general, you will have the best performance by keeping
your CDs and the mechanism clean.
• Store CDs in their cases, and keep them in cabinets or on
shelves.
• Keep the System's CD door closed when not in use.
Cleaning the Unit
• Stains on the Unit
Should be wiped off with a soft cloth. If the Unit is heavily
stained, wipe it with a cloth soaked in water-diluted neutral
detergent and wrung well, then wipe clean with a dry cloth.
• Since the Unit may deteriorate in quality, become
damaged or get its paint peeled off, be careful
about the followings.
- DO NOT wipe it with a hard cloth.
- DO NOT wipe it strong.
- DO NOT wipe it with thinner or benzine.
- DO NOT apply any volatile substance such as insecti-
cides to it.
- DO NOT allow any rubber or plastic to remain in con-
tact with it for a long time.
Cleaning the Lens
If the lens in the CD pickup is dirty, dropout, etc., could de-
grade sound.
Open the CD door and clean the lens as shown.
• Use a blower (available from a camera store) to blow
dust off the lens.
• If there are fingerprints, etc. on the lens, gently wipe
clean with a cotton swab.

Moisture Condensation

Moisture may condense on the lens
inside the System in the following
cases:
• After turning on heating in the
room.
• In a damp room.
• If the System is brought directly
from a cold to a warm place.
Should this occur, the System may
malfunction. In this case, leave the
System turned on for a few hours un-
til the moisture evaporates, unplug
the AC power cord, and then plug it
in again.
Blower
Lens
28