Installation; Transport; Define Location; Unpack And Check Equipment - Ingersoll Rand N2G17FP Manual De Operación Y Mantenimiento

Follow the instructions in this chapter to install the Nitrogen tire filling system.
• Put the Nitrogen tire filling system in the original box to transport over longer distances.
• For qualifications of personnel, refer to 2.1.
• The Nitrogen tire filling system is not designed for installation in an enclosed area.
• Install in a well ventilated area.
• When lifting tank mounted equipment always use the lifting eyes supplied on the tank along with appropriate lift-
ing equipment which meets all applicable standards and regulations (local, state, country, federal, etc.)
1. Install the Nitrogen tire filling system on a fixed location. The location must meet following requirements:
• Indoors
• Dry
• Vibration free
• No continuous direct irradiation by sunlight
• Away from heat sources
• Properly ventilated room.
• Easy accessibility for operating and service
• Clear of external hazards and/or protected from such hazards
Perform the complete installation procedure again if you move the Nitrogen tire filling system to a new location.
2. Transport the Nitrogen tire filling system to this location in a safe manner.
NOTE;
Use suitable lifting equipment (i.e. forklift) to lift and transport the unit to the installation site. Ensure the lifting equipment, straps, etc. are
capable of supporting the weight of the Nitrogen tire filling system.
1. Open the packaging.
2. Make sure that all components are delivered.
Make sure that the oil content of the compressed air is below 0.01 mg/m 3 .
3.
4. Make sure that the supplied compressed air is correct:
• If the Nitrogen tire filling system is connected to a house air system: Make sure that the compressed air pressure and quality is
always as prescribed. The capacity must be sufficient.
• If the Nitrogen tire filling system is connected to a stand-alone compressor: Make sure that the compressor works properly. Refer
to the instructions of the compressor supplier. Make sure that the after cooler and the water separator of the compressor works cor-
rectly.
• Make sure that the pressurized air dryer is of proper size and is fully functional.
• Failure to properly mount fully packaged "FP" units could allow the unit to easily be tipped over.
• Do Not operate the unit prior to proper mounting

5. INSTALLATION

5.1 Transport

5.2 Define Location

5.3 Unpack and Check Equipment

5.4 Anchor Equipment (Tank Mount Units Only, "FP")

WARNING
WARNING
WARNING
10
Form 04581138-Edition 1