Compressed Gas; Nitrogen And Oxygen; Safety Precautions - Ingersoll Rand N2G17FP Manual De Operación Y Mantenimiento

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Make sure that the gas pressure can not exceed the maximum allowed pressure. Refer to the product nameplate
located on the side of the unit.
Make sure that the equipment and the pipes are connected correctly for the occurring gas pressures.
Depressurize the Nitrogen tire filling system and the connected systems before you disconnect parts of the system.
The sudden escape of compressed gas can cause serious injury or damage.
HIGH PRESSURE NITROGEN. Bypassing, modifying or removing safety/relief valves can cause serious injury or
death. Do not bypass, modify or remove safety/relief valves. Do not direct gas stream at body.
HIGH PRESSURE NITROGEN. Rusted tanks can cause explosion and severe injury or death. Drain tank daily or
after each use. Drain valve located at bottom of tank.
RISK OF BURSTING. Use only suitable nitrogen handling parts acceptable for pressure of not less than the maxi-
mum allowable working pressure of the machine. Never modify or repair tank, obtain replacement from Service
Center.
The Nitrogen tire filling system generates nitrogen as a product. Oxygen enriched air is released as waste.
Nitrogen can cause suffocation!
Oxygen-enriched air leads to increased risk of fire in the event of contact with combustible products. Make sure
that there is adequate ventilation at all times!
The Nitrogen tire filling system is not designed for installation in an enclosed area.
Do not install the Nitrogen tire filling system in an area where explosive substances may be present.
Install in a well ventilated area.
Securely bolt tank units to the floor prior to using in order to prevent the unit from tipping.
Only feed the Nitrogen tire filling system with air.
Keep the air feed to the Nitrogen tire filling system clean and free of vapors of organic solvents and other contami-
nants. Do not place the Nitrogen tire filling system in a room where organic solvent vapours may occur in the air.
Keep the ambient temperature between 50 and 100 °F.
Install the peripheral equipment and piping according to standard procedures. Ingersoll-Rand cannot take respon-
sibility for equipment and plumbing installed by non-Ingersoll-Rand technicians.
Do regular maintenance to the Nitrogen tire filling system, to ensure proper and safe operation. Refer to chapter 8.
Make sure that instructions concerning health and safety are compliant with the local legislation and regulations.

2.2 Compressed Gas

WARNING
WARNING

2.3 Nitrogen and Oxygen

WARNING

2.4 Safety Precautions

WARNING
6
Form 04581138-Edition 1

Publicidad

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

N2g70fpN2g140fpN2g17N2g70N2g140

Tabla de contenido