Accessories - AERMEC IDROBLOC C Serie Manual Técnico Y De Instalacion

ACCESSORIES DATA
PR3 – SIMPLIFIED REMOTE CONTROL PANEL
Allows basic machine controls to be performed (turning on
and off, signalling of alarms, season changeover). The maxi-
mum allowed installation distance is 30 m with a cable with
shielding and a minimum section of 0.5 mm2, 6 poles.
In order to install the accessory PR3 up to a distance of 150m,
it is necessary to assemble the remote access card SDP on
IDROBLOC C.
PRD1 – INTELLIGENT REMOTE PANEL
It repeats the functions of the control panel on the machine,
but at a distance.
This accessory consists of a wall-mounting terminal (1) with
remote access up to 1000m that repeats the functions of the
panel on the machine, a card (3) for serial line transmission
to be mounted on the machine, and a 24VAC power supply
module (2) to be assembled near the terminal (max. 40m).
The display visualises the operating status of the machine
(summer/winter), the status of the compressor (on/off), and the
indication of the working hours of the compressor/pump after
100 hours.
Connect with a 6-pole cable plus shielding with minimum
section 0.5 mm2.
SDP – CARD FOR REMOTE ACCESS
Needed to be able to install the accessory PR3 up to 150m.
It must be installed on the unit itself, at less than one metre
from the command panel.
RA - ELECTRICAL STORAGE TANK HEATING ELEMENT
Electric heater element for the storage tank. Avoids the water
contained in the storage tank freezing during non-operation
during winter stops.
VT7 – VIBRATION DAMPING SUPPORTS
Group of four vibration dampers to be mounted under the
base plate, in the points already prepared. Used to attenuate
the vibrations produced by the compressor when in operation.
COMPATIBILITY TABLE
Mod. IDROBLOC
PR3
PRD1
RA
VT 7
* SPD
* SPD: install with the accessory PR3 when the connection cable is longer than 30 metres.
22
3C 5C
✔ ✔
✔ ✔
✔ ✔
✔ ✔
✔ ✔
D
C
Mod. A
VT7 20
B
A
8C
✔
✔
✔
✔
✔
B C D
20 20 M6