(7) MATRIX
Can select Matrix Modes, A or B. In normal condition, the A mode is
recommendable, but special cases such as under florescent lightings, or in-
door situation, the B mode is possibly better for optimum picture
(8) MONITOR
By L or R button, picture reproduction mode of monitor can be selected.
① CRT is for Cathode Ray Tube (Braun Tube) type monitors.
② LCD is for FDP, Flat Display Panel type monitors, such as LCD or Plasma.
(9) P.MASK
With E button, Privacy masking (P.Mask,
hereafter) control mode is available.
P.MASK can be set maximum 8 (eight)
points.
① Set to make it active (valid) or not.
By using U or D button, choose
desired Mask number/s, and make
it valid or invalid by L button for ON
(valid) or R button for OFF (invalid).
② Setting of Masking Area
The screen like the one on right
appears by E button after choosing
ON by L and R button.
1) Masking Area Size Change
Move a cursor by Arrow mark,
and use U or D button to move
upper or lower change. Or use L
or R button to move right or left
change.
2) Masking Area reposition
Move a cursor to MOV and push E button. Whole mask can be repositioned
by buttons, U, D, R or L.
Push E button to set a position and return to P.MASK area set screen.
3) DEF
This is for controlling the mask size, or to initialize a position.
4) DISP
This shows the Mask which was set valid. DIPS stands for Display.
5) RET
To return to Mask Set Screen.
PRIVACY MASK
MASK1 OFF MASK5 OFF
MASK2 OFF MASK6 OFF
MASK3 OFF MASK7 OFF
MASK4 OFF MASK8 OFF
PAINT GRAY
RET EXIT
↑
← MOV →
↓
RET DEF DISP
E-21