Features; Instructions For Use - 3M Pipettor II Manual De Instrucciones

3. ConTEnTs
• 1 3M Electronic Pipettor II - 5 mL
• 1 3M NiMH battery
• 1 Charging Stand
• 1 Transformer (AC Adaptor)
• 1 Test Performance Certificate
• 1 Important Safety Information
• 1 Quick Reference Card
• 1 Bag replacement Tip Cone Filters (50/bag)
Make sure all items are included and that no damage has occurred during shipment. Also check that the Transformer matches your electrical
requirements. (See adapter or Technical Data on Section 5).

4. fEaTUREs

• Pre-programmed pipetting and dispensing modes to perform common dilutions within the tip
• Open programming mode for user-set pipetting and diluting
• Automatic detection of calibration errors
• Nine speeds for aspiration and dispensing accuracy
• Electronic tip ejection buttons for both right and left handed users
• Soft-touch operating buttons
• LCD screen for viewing speed, mode and volume settings
• Cordless operation
• Recharging stand
• Replaceable NiMH battery
• Ergonomic design
The 3M Electronic Pipettor II - 5 mL meets the specifications outlined in the Standard Methods for the Examination of Dairy Products as well as the
FDA 2400 sheet criteria.

5. InsTRUCTIons foR UsE

aTTEnTIon: Allow the pipettor to remain in the charging stand for 12 hours to fully charge the battery if the battery is new or has been allowed to
fully discharge.
1.
Connecting the Transformer
• Ensure that voltage rating of the transformer correctly corresponds to the voltage from the electrical outlet.
• Do not use electrical outlets that are timed or switched.
• Use only the transformer provided with the unit or an approved replacement from 3M.
• Connect the transformer into the connector jack at the rear of the charging stand's base.
• Plug the transformer into an AC electrical outlet. When charging, the battery symbol will be displayed with the +/- symbols flashing in the
pipettor's display.
• When the battery is full the battery symbol disappears from the display. If the display shows REsET or PREss TIP, press the tip ejection button to
reset the pipettor. The pipettor will then be ready for use.
2.
3
(English)
3. 4.