Saving Measured Values To Memory - Store Function - Gossen MetraWatt GEOHM C Manual De Instrucciones

Ð
Entries can be made to the BUILDING, M-TYPE and CUSTOMER ID fields
one after the other, and a building designation can be entered with the
help of the softkeys.
Data Entry:
The desired alphanumeric characters can be displayed with the help
of the and keys, and then selected with the appropriate
softkey.
Control characters are entered in the same way and have the
following functions:
←: Move cursor to the left (without deleting characters)
→: Move cursor to the right (without deleting characters)
↵: Same function as the START key
After a character has been selected, the cursor moves one place to
the right. If the ↵ character is entered or the START key is pressed
(press at center), the cursor moves to the next field. After the BUILDING,
M-TYPE and CUSTOMER-ID fields have been completed and entries have
been acknowledged with the ↵ command, they are highlighted at the
display. After acknowledging once more with the ↵ character, a
designation for the currently selected building can be entered.

Note
This information is required by the PC software in order to enter
measured values to the database, as well as for automatic
generation of reports.
26
6.2 Saving Measured Values to Memory – STORE Function
Ð
Start the desired measurement. The STORE softkey is displayed after
the measurement instead of the INFO key.
The STORE key is not displayed until after a given amount of time has
elapsed for measurements which are performed without the START
key, so that the operator can first query the help text with the INFO key.
Ð
The displayed measurement values are stored to the currently
selected database memory address by briefly acknowledging with
the STORE key. The key is briefly displayed as an inverse image during
storage to memory.
Ð
Pressing and holding the STORE key allows for the entry of a comment,
and storage of the current measurement.
Entering a Comment:
Display the desired alphanumeric character with the
key and select the desired character with the corresponding softkey.
Control characters are displayed in the same way and have the
following functions:
←: Backspace and delete
↵: Same function as the START key
After each character has been selected, the cursor moves one place
to the right. Already entered characters can be deleted in reverse by
pressing and holding any softkey (except for ↵).
After entry of up to 15 characters, save the measurement values and
the comment by acknowledging with the START key (press at center) .
The following message appears: "Saving data".
or the
START
GMC-I Messtechnik GmbH