Kit Assembly - Metra 99-6516B Instrucciones De Instalación

ISO radio provision with pocket
1. Mount the ISO Brackets to the
radio with the screws supplied
with the unit. (Figure A)
2. Slide the radio into the radio
opening until the side clips engage.
(Figure B)
3. Snap the ISO Trim Plate into the
radio housing. (Figure C)
4. Snap the pocket into the radio
housing. (Figure C)
5. Locate the factory wiring harness
in the dash. Metra recommends
using the proper mating adapter
from Metra or AXXESS. Re-connect
the negative battery terminal and
test the unit for proper operation.
6. Reassemble dash in reverse order
of disassembly, using the new
Metra radio housing trim panel.

Kit Assembly

(Figure A)
right side clip
(Figure B)
(Figure C)
99-6516B
Double DIN radio provision
1. Cut and remove center divider in
radio housing. (Figure A)
2. Snap the DDIN brackets to the
inside edge of the radio housing.
(Figure B)
3. Slide the DDIN radio unit into
the DDIN bracket/radio housing
assembly and secure the radio
unit to the kit using the screws
supplied with the radio unit.
(Figure C)
4. Snap the DDIN trim-plate onto the
housing/radio assembly. (Figure D)
5. Locate the factory wiring harness
in the dash. Metra recommends
using the proper mating adapter
from Metra or AXXESS. Re-connect
the negative battery terminal and
test the unit for proper operation.
6. Reassemble dash in reverse order
of disassembly, using the new
Metra radio housing trim panel.
3
(Figure A)
(Figure B)
(Figure C)
(Figure D)