Checking the Horizontal Position of the Picture
Horizontal positioning (top view)
Ceiling Installation Using the PSS-2000
Installation for Twin/Triple Stacking
Changing the Polarity According to the Installation Condition
Install the projector so that the center of the lens is aligned with the
horizontal center of the screen.
Wall
Screen
Center of the screen
Refer to the Operating Instructions supplied with the PSS-2000 projector
suspension support.
Refer to the Operating Instructions supplied with the SU-PJ2000 projector
stand.
The polarity of the projector is adjusted at the factory to use the projector
for front projection on the floor.
When the projector is installed on the ceiling, it is necessary to change the
setting of INSTALLATION in the SET SETTING menu to project the
picture properly.
For details, see page 55 (GB).
Center of the projector
1
38 mm (1
/
inches)
2
Center of the lens
25
(GB)