Sony VPL-X2000U Manual De Instalación página 64

Maintenance
4
Replace the lamp cover and push to tighten the two
screws to fix the cover.
To replace a burnt lamp
If a lamp has burnt out, the FAIL LAMP indicator of
that lamp lights. Check the number of the burnt lamp,
and replace it with a new LMP-S2000 projector lamp
(not supplied).
Notes
• When replacing two or more lamps, replace the lamps
one after another paying attention to the connections.
• When replacing a lamp, be careful not to overtighten
the screws.
1
Remove the screw for the lamp to be replaced.
: l e a m p E x To replace Lamp 1
Screw for
Lamp 1
Screw for
Lamp 3
2
Remove the hexagonal nut to disconnect the cable.
64
(GB)
Screw for
Lamp 2
Screw for
Lamp 4
3
Remove the lamp heat sink.
4
Remove the lamp weights.
The positions of the weights to be removed vary
depending on Lamp 1–4.
Remove these
weights to replace
Lamp 1.
Remove these
weights to replace
Lamp 3.
5
Remove the lamp, and install a new lamp.
6
Secure the lamp by performing the steps above in
reverse order.
Tighten the screw for the lamp while pressing the
lamp against the lower left corner.
Remove these
weights to replace
Lamp 2.
Remove these
weights to replace
Lamp 4.