Cleaning The Air Filter - Sony VPL-X2000U Manual De Instalación

To reset the number of operated hours of
the lamps in the message display window
1
Plug in the power cord and set the projector to
standby mode.
2
Press the LIGHT, B, b and ENTER keys on the
control panel in sequence. Press each key within 5
seconds.
TIMER RESET?
LAMP: 1
3
Press the V or v key to display 1, 2, 3, 4 or ALL.
To reset the number of operated hours for Lamp 1,
2, 3 or 4, respectively, display 1, 2, 3 or 4.
To reset the number of operated hours for all the
lamps at the same time, display ALL.
TIMER RESET?
LAMP: ALL
4
Press the ENTER key.
TIMER RESET??
LAMP: ALL
5
Press the ENTER key again.
The projector will exit the reset mode if ALL was
selected in step 3.
If you selected 1, 2, 3 or 4, the display returns to
that in step 3. Go to step 6.
6
To exit the reset mode, display EXIT and press the
ENTER key.
If you want to reset the number of operated hours
of other lamps, repeat steps 3 to 6.

Cleaning the Air Filter

The air filter should be cleaned in every 100 hours.
When it becomes difficult to remove the dust from the
filter, replace the filter with a new one.
1
Turn off the power of the projector and unplug the
power cord.
2
Remove the air filter cover on the bottom of the
projector.
3
Remove the air filter.
4
Remove the dust from the filter with a vacuum
cleaner.
5
Attach the air filter and replace the cover.
Notes
• If the air filter is excessively dirty, wash it with mild
detergent solution and dry it in a shaded place.
• Be sure to attach the air filter cover firmly; the power
will not be turned on if it is not closed securely.
65
(GB)