Attaching The Lens - Sony VPL-X2000U Manual De Instalación

Before Installing the Projector

Attaching the Lens

Attach one of the following types of optional lenses to
the projector according to your purpose.
• VPLL-2009 fixed short focus lens
• VPLL-2014 fixed short focus lens
• VPLL-Z2019 1.3-times zoom standard focus lens
• VPLL-Z2025 1.6-times zoom long focus lens
• VPLL-Z2039 1.5-times zoom long focus lens
• VPLL-2075 fixed long focus lens
To attach the lens, follow the steps below.
Before attaching the lens
The lens ring used for the lens and the attaching
method vary depending on the types of lenses. Check
your lens type by referring below.
Unit type lens ring (supplied with the
projector)
The unit type lens ring is used for the VPLL-Z2025,
VPLL-Z2039 and VPLL-2075.
Assembly type lens ring (attached to the
projector)
The assembly type lens ring is used for the VPLL-
2014, VPLL-2009 and VPLL-Z2019. For the VPLL-
2014 and VPLL-2009, disassemble the ring by
removing the screws before attaching.
For VPLL-Z2019, attach the lens ring without
disassembling.
1
Turn the screws on the lens attachment part either
clockwise or counterclockwise by 90 degrees with
a screwdriver, then remove the cover from the lens
attachment part.
Cover of the
lens attachment
part
2
Remove the lens ring and the lens hole cover.
3
Attach the lens ring to the lens.
For VPLL-Z2025, VPLL-Z2039 and VPLL-2075
For VPLL-Z2019
Attach the lens washer to the lens ring with the
four screws.
Tighten the two
screws on the
rear sides.
Lens hole cover
Lens ring
This side faces
upward when
attached to the
projector.
Washer attached
to the lens
This side faces
upward when
attached to the
projector.
(continued)
23
(GB)