Description of Battery Level Icons and Charging
1
2
3
4
Note: Charge the CP after each use . A full battery should last for approximately 3-4 hours of use . If multiple implant procedures are scheduled
on a single day, charge the CP between procedures to ensure the battery does not run out . Always keep the CP power supply with the CP .
Note: The CP should provide 5 or more years of service . With repeated charging, the CP battery may lose capacity . Notify Axonics if you
experience a significant change in the operating time for a fully charged CP battery .
Determining the CP Battery Level
The battery icon shows the CP battery
level . This icon is always displayed in the
bottom left corner of the screen when
the CP is on .
The number of bars on the battery icon
indicates the CP battery level, and bars
disappear from right-to-left as battery
charge is depleted . The battery levels
show on this page are as follows:
1 Partially Full to Full (2 to 4 bars)
When 4 bars are present the
•
battery is full or nearly full . At 4 or
3 bars, the battery bars are white .
When the battery drops to 2 bars,
the bars are yellow indicating less
than half the battery charge is
remaining .
2 Low
When the battery level is low, the
•
battery displays 1 red bar .
Note: A procedure should not be started with a
low battery to avoid the CP battery dying during
the procedure .
Two minutes before the CP
•
automatically shuts down due to a
critically low battery, the user will
be prompted to charge the CP . This
prompt can only be disabled by
plugging in and charging the CP .
3 Charging
When the device is charging, the
•
battery icon shows 4 green bars
and a lightning bolt . Charging a fully
depleted CP can take up to 6 hours .
How to Charge the CP
To charge the CP, plug the power supply
into a power outlet and into the CP
( 4 ) . The power supply plugs into the CP
at the right end of the Connection Panel
and is indicated by the "Refer to manual"
symbol
17 17