Description Of Battery Level Icons And Charging - Axonics 2501 Manual Del Programador

Ocultar thumbs Ver también para 2501:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 264

Description of Battery Level Icons and Charging

Determining the CP Battery Level
The battery icon shows the CP battery level. This icon is
always displayed in the bottom left corner of the screen
when the CP is on.
The number of bars on the battery icon indicates the CP
battery level, and bars disappear from right‐to‐left as
battery charge is depleted. The battery levels show on
this page are as follows:
Partially Full to Full (2 to 4 bars)
When 4 bars are present the battery
is full or nearly full. At 4 or 3 bars, the
battery bars are white. When the
battery drops to 2 bars, the bars are
yellow indicating less than half the
battery charge is remaining.
Low
When the battery level is low, the
battery displays 1 red bar.
Note: A procedure should not be started with a low battery to avoid
the CP battery dying during the procedure.
Two minutes before the CP automatically shuts down
due to a critically low battery, the user will be prompted
to charge the CP. This prompt can only be disabled by
plugging in and charging the CP.
110-0085 rev E.indd 17
Charging
When the device is charging, the
battery icon shows 4 green bars and a
lightning bolt. Charging a fully
depleted CP can take up to 6 hours.
How to Charge the CP
right end of the Connection Panel and is indicated by the
"Refer to manual" symbol
Note: Charge the CP after each use. A full battery should last for
approximately 3-4 hours of use. If multiple implant procedures are
scheduled on a single day, charge the CP between procedures to
ensure the battery does not run out. Always keep the CP power
supply with the CP.
Note: The CP should provide 5 or more years of service. With
repeated charging, the CP battery may lose capacity. Notify Axonics
if you experience a significant change in the operating time for a
fully charged CP battery.
To charge the CP, plug the
power supply into a power
outlet and into the CP
( 4 ). The power supply
plugs into the CP at the
17 17
5/7/2020 11:53:13 AM

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido