Starting To Sew; Start And End Of Seam - Singer 3400 Manual De Instrucciones

Tabla de contenido

Publicidad

STARTING TO SEW

The machine will be set to (
turned on.

START AND END OF SEAM

1. Check the presser foot (General Purpose
Presser Foot). Refer to page 12 for
changing the presser foot.
2. Place the fabric under the presser foot.
3. Lower the presser foot.
The indicating lamp will turn to green.
4. Hold back both threads when starting
machine.
Let threads go after sewing a few stitches.
1
2
8
28
1
) automatically to sew straight stitches when power switch is
5. Regulate the speed while sewing.
6. Stop machine when you reach end of
7. Raise the presser foot lifter.
8. Remove the fabric and cut threads with
While sewing, special care is required
around the needle.
As machine will automatically feed the fabric,
do not pull nor push fabric.
7
seam.
the thread cutter, back to front.
CAUTION: To prevent accidents.
3
4
5
6
GRP
JMP
ENT
CL
A-
-
-
-
+
+

Publicidad

Tabla de contenido
loading

Tabla de contenido