Astralpool OPTIMA PRO NEXT Manual De Instalación página 17

Paragraph 13 – Password
Programming
+
PROG
Config.
Password
****
Password
0000
Paragraph 14 – Flow Alarm
Programming
+
PROG
Config.
Alarms
Flow
EM00136320
Flow
Off
Flow
On
Signals
6
Alarms
Flow
By setting the password, the programming section can be
accessed to view all the setup parameters, but every time
you try to change the settings you will be prompted for the
password.
The flashing line indicates the editable number; press
to select the number (from 1 to 9), then press
the number to modify, and then press
setting "0000" (default), the password will be eliminated.
Allows you to activate (deactivate) the flow sensor.
Once activated (On) by pressing the
the number of signals the pump requires before starting the
alarm (by setting the Time = 0 s on the next menu) or the
priming (by setting the Time different from 0 s in the next
menu). Press
press to set the value.
Press to confirm then press
menu.
In the Time menu you can set the time over which the pump,
not having received the flow signal for the set number of
signals, will start priming before starting the alarm. If during
the priming the pump receives again the flow signal, it will
return to normal operation. For the time = 0 s, after the set
number of signals, the pump will start immediately the alarm,
without performing the priming. To set and modify the time:
press and the number will start to flash, than press
to set the value. Press
to return to the main menu.
Only in Batch mode you can activate the Recovery mode.
The pump repeats the number of strokes not detected by the
flow sensor. Press
maximum number of signals that the pump can recover
before starting the alarm. Press
start to flash, than press
to confirm then press
rev.2.0 EN
Operation
Operation
and the number will start to flash, than
to return to the main
to confirm then press
to access the request of the
and the number will
to set the value. Press
to return to the main menu.
to select
to confirm. By
key, you can set
15