CAME FLUO-SW Manual De Ensamblado E Instalación página 40

4. ASSEMBLY PROCEDURE OF THE AUTOMATION
Check the stability, the weight of the leaf and that the movement is smooth and without friction (if necessary to reinforce the
frame). Any closing door device must be removed or completely deactivated.
Check the correct operation in case of installation on doors that divide environments at different pressures.
4.1 INSTALLATION OF PBB2 AUTOMATION WITH 001PBBA01 SLIDING ARM
Use the sliding arm to pull with doors which open inside (view from the automation).
Remove the cover and fix the automation in a stable and leveled way to the wall using the measurements shown in the
figure; refer to the axis of the door hinges.
Fix the sliding arm on the door as shown in the figure. Insert the sliding arm in the guide and fix to the automation.
Note: if necessary, you can change the measure H, between the automation and the door,
codes listed in the table.
(H) PBB2 automation
28 001PBBA01 + 001PBBA06
45 001PBBA01
62 001PBBA01 + 001PBBA08
Move the door manually, and verify the correct opening and closing smoothly.
Adjust the opening mechanical stop inside the sliding arm.
CLOSING OF THE AUTOMATION COVER
Fix the cover to the heads at the lower holes (or at the lateral holes), using the screws 2,9 x9,5 not supplied by us.
FA00008-EN v.7 – 05/2017 6
by replacing the spacer, using the
CAME S.p.A.