CAME FLUO-SW Manual De Ensamblado E Instalación página 55

7.7 ELECTRICAL CONNECTION OF A DOOR WITH 2 LEAVES
To coordinate the operation of two automatic swing doors with the closing overlap of the leaves (see figure), procedures as
follows.
Using a 3-wire cable (not supplied), connect the 2 automations MASTER-SLAVE, as shown in the figure.
Using the menu of the electronic control, set: ADV> SYNC> MAST on MASTER automation and ADV> SYNC> SLAV on SLAVE
automation.
Connect the opening sensors as described in chapter 7.5 and connect the safety sensors as described in chapter 6.6.
If desired, connect the function selector, as shown in the figure.
Note: the partial opening of only one leaf is referred to the MASTER automation.
FA00008-EN v.7 – 05/2017 21 CAME S.p.A.