CAME FLUO-SW Manual De Ensamblado E Instalación página 44

4.4 INSTALLATION OF PBBS2 AUTOMATION WITH 001PBBA02 ARTICULATED ARM
Use the articulated arm to push with doors which open outside (view from the automation).
If the door has the hinge on the left, disassemble the gear motor group from the automation and move the spring group
from the left side to the right side of the automation, as described in chapter 4.5.
Hinge on the left
Remove the cover and fix the automation in a stable and leveled way to the wall using the measurements shown in the
figure; refer to the axis of the door hinges.
Fix the bracket of the articulated arm on the door, using the measurements shown in the figure.
Note: if necessary, you can change the measure H, between the automation and the door,
codes listed in the table.
(H) PBBS2 automation
30 001PBBA02 + 001PBBA06
47 001PBBA02
64 001PBBA02 + 001PBBA08
FA00008-EN v.7 – 05/2017
Factory setting
10
by replacing the spacer, using the
CAME S.p.A.