Id Code Setup; Remote Control Unit - Marantz ZS5300 Manual Del Usuario

ID Code Setup

❖
Setting ID code
Set to ID-1
Ex.)

Remote control unit

INPUT
1
SET ID-1
REMOTE CONTROLLER RC5300ZS
Press and hold SET , then
Press ID-1 and release both.
The ZS5300 system can be expanded up to 3 units.
When using 1 unit alone, set the ID switch on the rear panel to "1".
To set the remote control unit to the ID number of the unit, follow the procedure below.
1. Press the SET button and hold it, then press the ID-1 button , then release both buttons.
This remote control unit has been set as ID-1. To set the ID to 2 and 3, follow the same procedure.
2.
3. When the batteries are replaced, the unit defaults to the factory setting of ID-1.
Note:
This is important, because if you have changed ID numbers, you will have to reset the ID number when the
batteries are replaced.
*Default setting for both the remote control unit and the unit is ID-1
8
VOLUME
2 3
ID-2 ID-3
Rear panel of the unit
ZONE 3 PRE OUT
R L
AUDIO IN AUDIO OUT ZONE DIRECT IN
R L R L R L
1
STATUS OUT
1
ZONE ZONE
2
3
ZONE 2 FLASHER
IN
T
SPEAKERS ( MINIMUM 6 OHMS )
SPE
ZONE ZONE 1 1
R R L L
T REMOTE CONTROL REMOTE CONTROL ID ID
SELECTOR SELECTOR
3 3
IN IN
EXT. EXT. INT. INT. 1 1 2 2 3 3
OUT OUT
ER
Set to "1".
ZONE 2 ZONE 3
R L R L