Preparation And Connection; Connecting Speakers - Marantz ZS5300 Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Preparation and Connection

Before making connections
Be sure to turn the power off for the ZS5300 and other products to be connected to ZS5300 before making
connections.
Please refer the instruction manuals for other products to make sure of the proper connections and terminals.
Keypad
The keypads that can be connected to the unit are keypads and connecting boxes made by NILES and XANTECH
shown below. If you want to use products that are not in the list below or made by other manufacturers, please
contact your authorized Marantz dealer.
• NILES
Keypad
IR Main System unit
IR Sensor
IR Flasher
• XANTECH
Keypad
Connecting block
IR Sensor
IR Emitter
Note:
When connecting a Keypad, refer to the instruction manual for the Keypad as well as for this unit.

Connecting speakers

There are 2 ways to connect speakers. See the
pictures below.
Connecting speaker wire
1. Strip away approx. 6/8 inch (20 mm) of wire
insulation.
Approx. 6/8 inch
(20 mm)
2. Twist the bared wire ends tight to prevent short
circuits.
3. Insert the bare part of the wire into the hole in the
each terminal as follow.
: IntelliPad
: IRP6+
: MS 2
: IRC-2
: SMARTPAD3
: 789-44
: 480-30 Series
: 282M
Connecting banana plug
Banana plug connections are also possible.
9

Publicidad

Tabla de contenido
loading

Tabla de contenido