Date & Time Set Procedure; Applying The Cuff - HoMedics HEALTH PLUS BPW-040-HP Manual De Instrucciones

DATE & TIME SET PROCEDURE
1. To adjust the date/time, press the SET button
. The display will show a blinking number
showing the MONTH.
2. Change the MONTH by pressing the
Each press will increase the number by one
in a cycling manner. Press the SET button
again to confirm the entry, and the screen will
show a blinking number representing the
DAY of the month.
3. Change the DAY, HOUR, and MINUTE
as described in Step 2 above, using the
button to change the numbers and the SET
button to confirm the entries.
repeat process to set the
DAY, HOUR, and MINUTE
button.
Press the button
blinking MONTH
increasing MONTH
confirm the entry
13

APPLYING THE CUFF

1. Remove all watches, wrist
jewelry, etc. prior to attaching
the wrist monitor. Clothing
sleeves should be rolled up
and the cuff should be wrapped
around bare skin for correct
measurements.
2. Apply cuff to left wrist with palm
facing up as shown in Fig. A.
3. Make sure the edge of the cuff
is about 1/4"~1/2" (1 cm) from
the palm as shown in Fig. B.
4. In order to ensure accurate
measurements, fasten the hook
and loop strap securely around
your wrist so there is no extra
space between the cuff and
the wrist as shown in Fig. C.
If the cuff is not wrapped tight
enough, the measurement
values will not be accurate.
5. If your physician has diagnosed
you with poor circulation in
your left arm, place the cuff
around your right wrist as shown in Fig. D.
Note:
• This device should not be used when your
wrist is wounded or injured.
• If it is not possible to use the cuff on your left
wrist, it can also be used on your right wrist.
However, all measurements should be made
using the same wrist.
14