Troubleshooting; Specifications; Auto-Shut-Off - HoMedics HEALTH PLUS BPW-040-HP Manual De Instrucciones

TROUBLESHOOTING

If any abnormality arises during use, please check the following points:
POSSIBLE
SYMPTOMS
CAUSES
Unit does not turn Batteries have
on when the START/
run down.
STOP button is
pushed.
Battery polarities
have been
positioned
incorrectly.
EE measurement Cuff has been
error symbol shown placed incorrectly.
on display or the
blood pressure
value is displayed
Did you talk or
excessively low
move during
(or high). measurement?
Shaking of the wrist
with the cuff on.
E1 error symbol Air circuit
shown on display abnormality.
E2 error symbol Inflation pressure
shown on display exceeding 300 mmHg.
E3 error symbol Error determining
shown on display measurement data.
EP error symbol System error.
shown on display
Note: If the unit still does not work, contact HoMedics Consumer
Relations. Under no circumstance should you disassemble
or attempt to repair the unit by yourself. Contact informa-
tion for HoMedics Consumer Relations Department can be
found on the warranty page.
CORRECTION
Replace them
with two new "AAA"
alkaline batteries.
Re-insert the
batteries in the
correct positions.
Wrap the cuff
properly so that it is
positioned correctly.
Measure again.
Keep wrist steady
during
measurement.
Measure again.
Measure again.
Switch the unit off,
then measure again.
Measure again.
Measure again.
31

SPECIFICATIONS

Power Source:
Measurement Method:
Measurement Range:
Accuracy:
Pressure Sensor:
Inflation:
Deflation:
Memory Capacity:

Auto-shut-off:

Operation Environment:
Storage/Transportation
Environment:
Two 1.5V DC "AAA" Alkaline
batteries (not included)
Oscillometric
Pressure: 40~280 millimeters
Mercury (mmHg)
Pulse: 40~199 beats/minute
Pressure: ±3 mmHg
Pulse: ±5% of reading
Semi-conductor
Pump driven
Automatic Pressure release
valve
99 memories
1 minute after last button
operation
Temperature: 41°F~104°F
(5°C~40°C)
Humidity: 15% ~ 93% RH
Temperature: -13°F~158°F
(-25°C~70°C)
Humidity: Less than 93 RH
32