Fitting The Harness - Stihl FS 300 Manual De Instrucciones

Fitting the Harness

To use the harness – see chapter
"Approved Combinations of Cutting
Attachment, Deflector, Handle and
Harness".
Shoulder strap
2
3
We recommend using a full harness for
this machine, because of its weight and
for ergonomic reasons.
FS 300, FS 350, FS 380
Full harness
1
The full harness is supplied together
with an information sheet showing how
to fit it.
Fitting the harness
Put on the harness (1)
N
Adjust the strap length so that the
N
snap hook (2) is approximately a
hand's breadth below the right hip.
Attach the snap hook (2) to the
N
perforated strip (3) on the machine
– refer to next chapter 'Connecting
machine to harness'.
Balance the machine – refer to
N
chapter 'Balancing the machine'.
Trim excess strap lengths at the ends
after adjusting.
1
4
2
3
Connecting machine to harness
1
2
The type and functioning of the snap
hooks may vary.
Hook the snap hook (1) into the
N
perforated strip (2) on the drive tube
English
2
1
2
1
69