Fitting The Full Harness - Stihl FS 311 Manual De Instrucciones

WARNING
Never remove the cap by turning it
directly to the open position. First allow
the power tool to cool adequately and
then release any residual pressure by
slowly turning the cap approximately
1/2 turn counter-clockwise. Never
attempt to remove the cap while the
engine is still hot or running.
Refueling
Take care not to spill fuel while fueling
and do not overfill the tank – leave
approximately 1/2" (13 mm) air space.
Closing
WARNING
An improperly tightened fuel filler cap
can loosen or come off and spill
quantities of fuel. To reduce the risk of
fuel spillage and fire from an improperly
installed fuel cap, tighten the fuel filler
cap by hand with as much force as
possible:
FS 311
If your fuel cap still does not tighten
N
properly, it may be damaged or
broken. Stop using the power tool
and take it to your authorized STIHL
dealer for repair or replacement.

Fitting the Full Harness

2
3
Put on the full harness (1).
N
Adjust the length of the strap so that
N
the spring hook (2) is about a hand's
width below your right hip. Over-
long ends of straps may be
shortened after completing the
adjustment.
Attach the spring hook to the
N
machine's perforated strip (3).
Find the right attachment point for the
cutting attachment you are using – see
"Balancing the Brushcutter".
English
1
29