Jøtul F 480 Instrucciones Para Instalación página 9

Fig. 9
A
A
6. Loosen the height adjustment screws slightly (A) beneath
the product so that they can be screwed by hand. NB: If the
optional glass fl oor plate is to be installed, the base must
be raised approximately 8 mm off the fl oor so that it can be
pushed under the front edge of the base.
Fig. 10
7. Carefully remove the wooden pallet.
8. Place a packaging frame (A) crosswise underneath the
base/pedestal/leg and cardboard packaging in front of/
beneath the product to prevent it from making marks on
the fl oor. Carefully raise the stove and stand it in its proper
place (fi g 1). Remember to position it straight above or
behind the external air supply, whichever is applicable.
9. Place the top plate (fi g. 3 A) temporarily in place and
level the fi replace. If the stove is not standing level, adjust
the screws shown in fi g. 9 A until the product is perfectly
straight.
10. If the control handles (Fig. 3C) are diffi cult to pull out, see
step 4.6
4.9 Location of approval label
The approval label must always be affi xed to the wire and
positioned as illustrated in fi g. 11.
Fig. 11, Base
A
A
Fig. 11, Pedestal
A
ENGLISH
A
A
9