Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
English
Adjusting the optional Skoocher system (Continued)
EN
Adjusting for Trendelenburg Positioning
To adjust for Trendelenburg positioning, press the Trend/Pelvic Tilt button on the siderail (see
(Outside siderail) on page
page
1-39). Release the button when you achieve the desired angle.
Adjusting for Pelvic Tilt
Pelvic tilt provides additional tilt and comfort for the patient when you raise the fowler.
To adjust for pelvic tilt, press the Trend/Pelvic Tilt button on the siderail (see
page
1-34) or on the optional pendant (see
the button when you achieve the desired angle.
Adjusting the optional lumbar pillow
The inflatable, full-width lumbar pillow supports the patient for back labor, and the seat pillow enhances perineal visibility.
To adjust the lumbar pillow, see
siderail) on page
Note: The lumbar controls are only compatible with the Air mattress.
Illuminating the room with the night light
The Birthing Bed is equipped with a night light that illuminates the floor area. The night light automatically activates when
the light in the room becomes dim.
Positioning the Glideaway footrests
To position the Glideaway footrest:
1.
Grasp the footrest and pull it up and around the foot section
2.
Grasp and attempt to move the footrest to make sure that the footrest is locked in the upright position.
3.
To stow the footrest, pull the purple lever that is located at the bottom of the footrest mechanism
page
1-23).
1-22
Figure 1-18: Skooch in
1-34) or on the optional pendant (see
Motion pendant functions (optional) - 5000-081-021 on page
Patient lumbar control functions with optional Smart TV and optional Air Mattress (Inside
1-38.
Operation
Figure 1-19: Skooch out
Motion pendant functions (optional) - 5000-081-021 on
Nurse control panel (Outside siderail) on
(Figure 1-20 on page
4701-209-0 01 REV A
Nurse control panel
1-39). Release
1-23).
(Figure 1-22 on
www.stryker.com
Publicidad
Capítulos
Tabla de contenido
