Positioning The Lock-Rite Foot Section; Positioning The Patient On The Birthing Bed - Stryker Birthing Bed Manual De Instrucciones

English

Positioning the Lock-Rite foot section

EN
WARNING
Do not use the foot section locking bar as a grasping bar or other patient assist device.
To position the Lock-Rite foot section:
1. Position the patient's perineum out and over the edge of the perineal edge.
2. Lower the foot section to its lowest position.
3. Place and position the patient's feet on the footrests or legs in the optional calf supports.

Positioning the patient on the Birthing Bed

WARNING
Always leave the product in the lowest position when the patient is unattended to help reduce the number and severity of
patient falls.
CAUTION
The maximum safe working load of the foot section is 300 lb.
To position the patient on the Birthing Bed:
1. Place and position the patient's feet on the footrests.
2. Raise or lower the footrests to a position that is comfortable for the patient.
3. Remove the foot section.
4. Press the Litter Up button (see
comfortable height. Release the button when you achieve the desired height.
5. Position the patient's perineum out and over the edge of the perineal edge.
Other possible patient positions:
Upright Sitting
You can position the footrests or
optional calf supports for the patient
with the foot section still intact. This
allows the operator to provide hands-
free care from the foot end of the
1-16
Nurse control panel (Outside siderail) on page
By supporting themselves on the
labor bar, the patient can fully stretch
the pelvis and vaginal opening,
allowing the baby to descend.
bed.
Operation
Squatting
4701-209-0 01 REV A
1-34) to raise the bed to a
Resting/Squatting
The use of a high semi-fowler and of
the Skoocher system allows for a
comfortable resting position.
www.stryker.com