Using The Miter Gauge; Using The Outfeed Support - Delta 36-6022 Manual De Instrucciones

USING THE MITER GAUGE

There are two miter gauge grooves. one on either side of the blade. When making a 90º cross cut, use either groove. For
beveled cross cut use the groove on right so that the blade is tilted away from miter gauge and hands.
Loosen the miter gauge lock knob. Rotate the gauge until desired angle on scale is reached. Retighten lock knob.
See Figure 52.
USING THE REAR OUTFEED SUPPORT
The out-feed support slides out to provide additional support for cutting long work pieces.
Ensure the power switch is in the OFF position. From the rear of the saw, grasp the out-feed support with both hands
until it is fully extended.
See Figure 53.
MAKING ADJUSTMENTS
LOCK
KNOB
FIGURE 52
FIGURE 53
39