Height Adjustment Knob Installation; Blade And Guards; Attach The Blade - Delta 36-6022 Manual De Instrucciones

Height Adjustment Knob Installation

1. Insert wheel handle shoulder screw (jj) into height adjustment wheel knob (kk) as shown in Figure. 17.
2. Tighten shoulder screw with Phillips Screw Driver into the Hand Wheel. Height adjustment wheel knob should rotate
freely around shoulder screw when raising or lowering the blade with the Height Adjustment Hand Wheel.

BLADE AND GUARDS

Attach the Blade

After installing height adjustment knob as shown in Figure. 17, raise motor/arbor assembly to the upper
most position to provide easy access to riving knife lock lever and arbor assembly.
Ensure riving knife lock lever is in unlock position. See Figure. 18.
Detach the on-board wrenches located on the right side of the saw by loosening and removing M8 wing
nut.
Place the open-ended wrench (a) on the spindle shoulder between the arbor flange and inner flange.
Place the closed end wrench (a) over the arbor nut. Holding the spindle shaft in place, loosen and remove
the arbor nut and arbor flange.
See Figure 18.
ASSEMBLY
jj
kk
FIGURE 17
a
FIGURE 18
19
UNLOCK
POSITION
CLOSED END
WRENCH