Unscheduled Maintenance - Zhermack VAP 6 Manual De Instrucciones

UNSCHEDULED MAINTENANCE

8.3
Unscheduled maintenance includes repair of any accidental breakage and replacement of worn or
malfunctioning parts.
All electrical and mechanical work must only be carried out by an authorised
Zhermack maintenance technician.
Modifications which alter the equipment characteristics from a safety and risk
prevention viewpoint may only be made by the Manufacturer who shall then issue
a certificate stating that the equipment conforms to safety standards. Therefore
any modification or maintenance tasks not actually described in this manual are to
be considered forbidden. If the equipment is modified, tampered with or repaired
by unauthorised personnel or non-original spare parts are used the manufacturer
is relieved of all responsibility. If a maintenance task is required but is not
described in this manual you must contact an Authorised Servicing Centre.
8.3.1 Emptying the water from the boiler
To empty the VAP 6A boiler quickly proceed as follows:
• Turn the main switch (4) to off.
• Select the water function via the mode switch (16).
• Drain the water by pressing the gun trigger button (9).
If, instead, you are emptying the VAP 6 proceed as follows:
• Switch off the machine via the main switch (3) and disconnect the plug from the mains power
socket.
• Wait for the equipment to cool down completely (this takes about 40 minutes).
• Unscrew the water filler plug (15).
• Grip the unit by its base, turn it upside down and pour the water into a suitable recipient (see
illustration below).
154 of 328
EN
It is strictly forbidden to empty the machine as
described above when it is switched on or under
pressure. The Manufacturer cannot be held liable
for any damages caused by any failure to observe
the above information and instructions.
The machine is heavy: at least 2 (two) workers are
required to turn it upside down.
MAINTENANCE AND USE MANUAL
VAP 6 / 6A - AD 8