NOTICE: Be careful not to pinch or damage the front cover sealing when attaching the front cover. Any damage to the sealing may allow moisture or oil to enter the drive

case and damage components.

NOTICE: Equipment Hazard. Be sure to fastening all screws in accordance with specified tightening torque. If any screws are loose, water and oil may seep into the case

and damage the drive.

For drives with digital operator in the front cover insert the LED operator cable back into the correct port on the drive.

Place the front cover back onto the drive, and fasten the cover screws applying the following tightening torque values:

Drives CIMR-VCBA

Drives CIMR-VC4A0018 to 0038: 2.5 Nm

Cable Glands

NOTICE: Equipment Hazard. Use only the recommended multiconductor cable and use one cable per cable gland only. Attempting to pass more than one wire through a

cable gland will result in a space between those wires, thus considerably reducing the water-proofing and dust-proofing capabilities of the cable gland, and may

result in damaging the drive.

NOTICE: Make sure that the rubber edging along the outside of the cable gland is properly sealed. Failing to properly seal the outside may allow water or oil into the drive

and damage components.

Cable Glands Specifications and Model Numbers

YASKAWA recommends using SKINTOP cable glands by Lapp Kabel for use with V1000 Series IP66 Type.

EN 10

Cable

EMC Filter

Terminals

and CIMR-VC4A0001 to 0011: 1.5 Nm

Cable Glands on page

grounding

of cable shield

Cable Gland