Installation; Opening Cable Knockouts (Fig. 4); How To Remove The Front Panel (Fig. 5); Unit Fixing Position (Fig. 6) - Carrier Aquasnap 30RB Manual De Instalación

3 - InSTallaTIon

Before installation, check strength and horizontality of the
base so that abnormal sound does not generate.
According to the dimensions and clearances, fix the base
firmly with the anchor bolts (Anchor bolt, nut: M10 x
2 pairs).
If the outdoor unit is installed in a very windy place,
protect the fan with a wind protection screen and check
that it works correctly.

3.1 - opening cable knockouts (fig. 4)

There is a pre-cut part that can be removed for running
wires. Do not remove the unit front panel for easier
drilling of theknockouts. The pre-cut section of the sheet
can be removedby punching the 3 connection points along
the line first using a screwdriver and finally with your
hands (See Fig. 4).
When the cable knockout is open, remove the burrs and fit
the cable protective bush supplied with the unit for cable
protection.

4 - dIMenSIonS and clearanceS

For dimensions see fig. 1
30rB A
008-9008X9 908
012-9012X9 908 1363
015-9015X9 908 1363
Mimimum installation clearances in mm are shown in fig.2 (single installation) and fig. 3 (serial installation)
Mimimum Gross weight refers to the unit as shipped with packging. Net weight refers to unit with packaging removed.
NOTE: The height of the obstacle at both front and rear side should be lower than the height of the outdoor unit.

5 - SafeTy procedureS

5.1 - Servicing and maintenance

CAUTION:
• Ensure adequate personal protective equipment is
used.
• Extraordinary maintenance operations must be
carried out by specially trained personnel.
Disconnect the mains power supply prior to any
maintenance operations or prior to handling any internal
parts of the unit.
B C d e
821 326 350 87
326 350 529
326 350 529

3.2 - How to remove the front panel (fig. 5)

1. Remove screws of the front panel (See fig 5).
2. Pull the front panel downward with the handle.

3.3 - unit fixing position (fig. 6)

See fig. 6.
For correct unit installation use the dimension indicated.

3.4 - operating limits (fig. 7)

Operation in cooling: See fig. 7
A- Outdoor air temperature (°C)
B- Outlet water temperature (°C)
f g h l
356 466 40 60
995 1105 44 69
995 1105 44 69
CAUTION:
• This equipment contains refrigerant that must be
disposed of in a proper manner.
• When disposing of the unit after its operational life,
remove it carefully.
• The unit must then be delivered to an appropriate
disposal centre or to the original equipment dealer
for proper environmentally compatible disposal.
Net weight gross weight
75.5 82.5
73.5 80.5
114 121
108 114
116 123
110 116
17