Sime Brava One BF Manual De Instalación Y Mantenimiento página 86

4
3
- remove the four screws (3) and remove the front panel (4)
from the combustion chamber (6) working carefully so as not
to damage the gasket or the panel insulation
5 6
- remove the screw (7) and extract the electrode (8)
- remove the swivel joint (9) and the counter-nut (10)
- remove the screws (11)
- remove the gas manifold (12), replace the nozzles fitted in the
factory with the nozzles supplied with the accessory kit and
position the gaskets
12
11
7
- refit the gas manifold (12) securing it with the screws (11)
86
Fig. 39
Fig. 40
8
10
9
Fig. 41
- tighten the counter-nut (10) and the swivel joint (9) and
position the gasket
- refit the electrode (8) putting its end IN THE MIDDLE of the
burner element (*)
- check that the gasket and the insulation of the front panel (6)
of the combustion chamber and the gasket (13) of the front
panel (4)of the sealed chamber are all integral. If they are not,
replace them
- refit the panels (6) and (4) securing them with fastening
screws
m
CAUTION (*)
The position of the electrode is essential for the correct
detection of current ionization.
13
4
3
- apply the label indicating the new gas configuration on the
technical plate (14) on the inside of the front panel
- carry out the "Automatic calibration procedure" and then
refit the front panel (2) securing it with the two screws (1).
2
14
EN
Fig. 42
1
Fig. 43